HOW to USE: TS-Block (Y-TS) by Mangrove Products®

Specifically designed for Yamaha F150XC-F200XC 2023 or Newer Tilt/Trim Systems

Installation

1. LOCATE Single-RAM/Vertical Piston.

2. TILT Outboard UP to the Highest Position.

3. APPLY TS-Block Y-TS with "Mangrove Products" colored logo Facing Rear (Easier to lead into piston with corner of TS-Block.

4. When Applying TS-Block Y-TS PLEASE ENSURE Tapered section is facing UP.

5. TURN the TS-Block Y-TS 180 degrees or 1/2 turn (If in correct position you will see arrows on left and right side of opening with Arrow Pointing UP.

6. BEFORE Compression ensure the corners of the TS-Block Y-TS are Aligned between BOTH Grease Fittings or Zerks.

7. Compress/TILT Outboard DOWN to make contact with rubber, then press DOWN button 1 time (normally 1/4 inch of pressure)

Removal

1. TILT Outboard UP to highest position

2. Apply Downward Pressure to release rubber tapered end from upper T-Bracket (NOTE: Your first compression will appear that the TS-Block is stuck in place, however this is normal with the first compression. To release from this position grab TS-Block and push (left/right) while applying downward pressure. This will release the rubber from the T-Bracket). Your 2nd compression will release much easier and will not require this release method.

3. Place TS-Block Y-TS into your storage. Do NOT leave compressed on your outboard to prevent rubber memory in the compressed position. 

When Using

To prevent rubber memory, Please Ensure to REMOVE TS-Block Y-TS from Piston after each use.

DO NOT leave TS-Block compressed on Single RAM piston for extended periods of time (Memory will occur after approximately (5-7 days) depending on heat conditions.

Additional Questions

Call Mangrove Products® Support +1 (954)-253-8883 We are here to help.