Transom Saver (Yamaha) TS-Block (1)-GEN-2-Outboard Support for Yamaha 2023+ 150hp & 200hp

🟠 Estimated Release Date: 9/15/25 to 9/30/25. 

🟢UPGRADED MATERIAL GEN-2: NEW Pressure rating to over 2000 lbs. compression specifically designed for Yamaha 2023+ 150hp-200hp outboards (see fitment guide)

✅Fitment Guide: (UPDATE)

YAMAHA 4-Stroke/2-Stroke: 2023+ Year F150XC and F200XC (150hp-200hp) Specific.

✅ NOTE/INFO: This is currently the only rubber transom saver variation available for Yamaha's new single ram tilt/trim system. Our new upper taper design allows the custom TS-Block to bypass Yamaha's new dual grease zerks and fit snuggly into place without damaging your outboard. It is important to note that placement with the "Mangrove Products" logo to face forward before compression for best fitment. 

✅ Easy to Use: No drilling or special installation to trailer required, no need to bend over or get on your knees. Eliminate metal to skeg scrapping compared to metal transom savers. Simply tilt engine up, insert high pressure wedge into Tilt Ram piston, then tilt down and you are on your way. No metal, no worries of rust or corrosion and is safe to use in both salt and freshwater applications. No need for straps, rope, bungies, skeg support, or brackets. All you need is the high pressure wedge.

✅ Upgraded Design/High Pressure System: High Density EPDM rubber wedge trail tested and constructed better by Mangrove Products. Compression testing over 2000 lbs of pressure, extended wedge length to aid in higher skeg ride height, withstand extreme hot/cold temps, 10 inner notches to ensure connection to tilt shaft, colored visual surface, and ergonomic design for storage in dry box. High pressure between the wedge and base of engine will not create splitting or damage to the wedge unit.

✅ Simplify Boating: Make your life easier and more enjoyable by eliminating the worry of potential damage your outboard motor or transom when trailering your boat to your favorite fishing spot with the family, so you can focus on the fun. Creating a barrier to downward force of gravity can positively reduce damage to tilt and trim unit when hitting bumps on roads and highways. The High pressure wedge creates this safe barrier to brace and prevent negative downward force to the tilt/trim unit.

✅ Safe Trailering: You will note a decrease in upward and downward force of the outboard when hitting bumps in the road so engine can move with trailer springs rather than direct impact to transom and tilt/ trim unit. Upward and downward force/ momentum can put unwanted pressure on your boats transom. Also you will note safe skeg travel in comparison to road height to aid in clearance to avoid damage by hitting road debris or road dips when pulling out of a parking lot.

⚠ WARNING: Patent PENDING